Altec Lansing Industrial Professional Sound Products Spec site

ALTEC LANSING INDUSTRIAL PROFESSIONAL SOUND PRODUCTS AMPLIFIER LIST

Altec Amplifier Specification section

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

 

Altec 9441A 100 watt Dual Channel Power Amplifier

page 5

<< Previous

Altec 9441A Amp page 5

CLICK ON IMAGE FOR FULL RESOLUTION SCAN IMAGE

PowerConnection: IEC Receptacle. 6 ft (1.83 m), 3-wire, 16 GA power cord with NEMA 5-15 plug supplied.

Fuse Type: 4 amp/250 volt Slo-Blo or equivalent for 120 V ac use.

Power Requirements: 120 V ac, 50/60 Hz, 300 watts. Configurable to 220/240 V ac. 100 V ac, 50/60 Hz model is also available.

AC Voltage Operating Range: Operates from line voltages as low as 90 volts (at reduced output power assuming 120 V as nominal line voltage.

Power Consumption
and Heat Produced: (Both channels operating in dual mode with 1 kHz sinewave input signal at stated output power into 4 ohm loads)
Idle: 30 watts / 0.102 kBTU per hr.
1/8th max midband power: 270 watts / 0.833 kBTU per hr.
1/3rd max midband power: 390 watts / 1.099 kBTU per hr.
Rated output power: 600 watts / 1.360 kBTU per hr.
Max midband power: 730 watts / 1.496 kBTU per hr.

Operating Temperature
Range: Up to 50 °C (122 °F) ambient

Dimensions:
Height: 1.75 inches (4.44 cm)
Width: 19.0 inches (48.26 cm)
Chassis Depth: 12.8 inches (32.51 cm)

Net Weight: 18 lbs (8.16 kg) Shipping Weight: 22 lbs (9.97 kg)

Color: Black

Enclosure:
Chassis: 16 GA steel.
Front Panel: 3/16 inch thick 5052 aluminum
alloy.

Standard Accessories: 2 - "U" jumper plugs installed in each accessory octal sockets.
Operating Instructions and Service Manual.
T2 A/250 V fuse for 220/240 volt operation.

Optional Accessories: * 14712A Power Limiter module.
15505A Input Bridging Transformer.
15515A Input Bridging Transformer with Pad.
15170 100 watt Output Transformer.
* 15581A 24 d B/oct Li n kwitz

Riley Crossover module.
15594A-xxx 18 dB/octave Low Pass Filter modules. Available in 125, 500, 800 and 1,250 Hz frequencies.
15595A-xxx 18 dB/octave High Pass Filter modules. Available in 125, 315, 500, 800 and 1,200 Hz frequencies.
15599A Bass Boost module.

* Note: The 14712A, and the 15581A will extend 0.625 inches (1.58 cm) above and below the chassis back panel when installed.

 

Next >>

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

aLTEC aMPLIFIER aCCESSORIES SECTION Altec Microphone section Altec Mixer Section  
Altec Powered Mixers and Misc
Altec Signal Processing sections
 
Specifications Catalog Table of Contents

 

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION