Altec Lansing Industrial Professional Sound Products Spec site

ALTEC LANSING INDUSTRIAL PROFESSIONAL SOUND PRODUCTS MIXER LIST

Altec Mixer Section

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

 

1674C & 1678C Automatic Microphone Mixers

page 2

 

<< Previous

1674C & 1678C Automatic Microphone Mixers

1674C and 1678C Automatic Microphone Mixers

Frequency Response: ± 1 dB from 35 Hz to 15 kHz

Total Harmonic
Distortion: Less than 0.2% (0.8% in automatic) and from 35 Hz to 15 kHz at +14 dBm (3.88V into a 600 ohm load) Chan In to Main out channel fader and master fader at nominal levels.
Hum and Noise (IHF "A"
weighted ASA Z24.3
1944): -128 dBm EIN (150 Q termination) Channel In to Line Out

Inputs: 4/8 x Channel Inputs (Transformer Balanced)
_ 1 x Link Input
1 x Mute/Priority
control

Mixing Buses: 1 x Mix
1 x Premix

Control Buses: 1 x Reference 1 x Priority

Outputs: 4/8 x Line Outputs
4/8 x Logic Outputs
1 x Link Output
1 x Main Output
(Transformer Balanced)

Attenuators: 4/8 X Automatic VCA's 0 to 20 dB attenuation Channel Level
Indicators: 4/8 x LED's indicate VCA and logic output states

Controls and Switches: 4/8 x Channel volume
1 x Master volume
1 x Auto/manual
1 x Master/extension 4/8 x Preamp Gain 4/8 x Phantom Power 4/8 x Hi-Pass Filter 4/8 x Auto/direct 1/2 x Mic/line
Line Voltage: 100, 120, 200, 220, 240 VAC selectable nominal voltages ±15%, 50 or 60 Hz

Power Consumption: 25 watts maximum

Finish: Black

Dimensions: 3'/z" (8.9 cm) H x 19" (48.3 cm) W x 121/2" (33.7 cm )D

Weight: Model 1674C, 16 lbs. (7.3 kg) Model 1678C, 18 lbs. (8.2 kg)

Warranty: Limited, one-year parts and labor
t In these specifications, when dB represents a specific voltage, 0

dB is referenced to 0.775 volts rms. 0 dBm is a power level
referenced to 1 mW (0.775 volts driving a 6000 termination). For example, when 6.16 volts drives a high impedance, the level
is designated "+18 dB (6.16V)". When 6.16 volts drives a 6000 termination, the level is designated "+18 dBm".
`Signal at LINK OUT connector, pin 1.
"Signal at LINK IN connector, pin 1.
"'Signal at LINK OUT connector, pin 3. ""Signal at LINK IN connector, pin 3.

Next >>

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

aLTEC aMPLIFIER aCCESSORIES SECTION Altec Amplifier Section Altec Microphone section  
Altec Powered Mixers and Misc
Altec Signal Processing sections
 
Specifications Catalog Table of Contents

 

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION